NOTE:

V1: Basic version, no loop for hook.

V2: Reinforced loop for line and vertical loop for hook.

V3: Horizontal hook loop for strength.

This is a simple tadpole I sculpted in Meshmixer, which I then moved to Tinkercad for the loops. Many freshwater fish bite at tadpoles, but I don't know about saltwater. I would love to hear about any fish caught and where, if anyone ends up printing this. Have fun and keep 3D printing! (and downloading my models)

Recommended Settings:

• 0.1mm Layer Height (it is a tiny model, so this is to get all the detail)
• 100% Infill (so it doesn't float)
• 2 Wall Loops
• Supports
  • Normal Supports
  • Snug Supports

Optional Settings:

• Make Overhangs Printable (optional, available in Orca and Cura but not Bambu)
• 50% Speed/Silent Mode (made no difference for me)