Thicker allen key handles
Remixed by
Copyright Claim
Thicker allen key handles
Remixed by
Boost
16
32
8
Print Profile(1)
0.2mm layer, 3 walls, 25% infill
Designer
8.4 h
6 plates
Open in Bambu Studio
Boost
16
32
8
0
46
58
Released
Description
This is the remix of the allen key handles by OlleMark. His handles are very well design but for my “little” hands I've found them a bit small. And for that reason I always buy screwdrivers and other tools with thicker handles. In this case it was quite easy to add a litle more body to the otherways perfect design.
It also cuts the print time of the original in half.
Because of thicker base and endcaps my handles can now stand upright on the table.
New: skadis holder for those handles: https://makerworld.com/en/models/453997#profileId-3614
Comment & Rating (8)
All
I like these and printed a few of the sizes. These are really comfortable to use. I like that they stand upright on the handle cap.
It would be nice to have an AMS version where the size is a different filament. In fact, an AMS version wouldn't need the complex screw on cap since a filament change is all that is needed.
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
thx
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
thread is a little tight, I feel it's more my fault.
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
Really nice print.
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld