Chonky cat napkin holder, or use it for whatever you like- paper work, coasters, paper plates or handguns!

Its quite large at 100%, the 3mf is scaled to 75% which is good for the standard napkin and lets you print the whole thing on 1 bed for P and X series users. "A" series users will need to print each half separately, depending on scale. You can just scale Z to make it narrower, scale to your desires based on what you are using it for. 

Print as oriented without support. The 2 halves just snap together with a friction fit, but you may need to use glue depending on your filament, etc. There is also a 1 piece version, but that is a more difficult print and will require support. Textured plates recommended as it comes out really nice, having texture on the primary faces that will be seen.

-0.2mm LH

-4-5 walls

-extra top horizontal layers to help strengthen the joining tabs on the L chonker

-use 5mm or more brim

-15-20% infill is adequate

-any filament should work