Search models, users, collections, and posts
Dehydrator Riser
IP Report
GIF
Print Profile(1)
0.24mm layer, 3 walls, 15% infill
Designer
4.3 h
2 plates
Open in Bambu Studio
Boost
14
27
6
3
49
4
Released
Description
Content has been automatically translated.
Designed for dehydrators with a diameter of approximately 27mm.
The purpose of the riser is to provide an affordable solution for using the dehydrator for filament drying. Due to the print size, it cannot be printed as a single piece, so it has to be printed separately and then assembled.
Snap-in connectors for easy assembly, just print and install, no glue or tape required.
The height can be adjusted by choosing 3cm (top layer) or 4cm (middle layer) according to your needs.
PETG material is recommended for printing, as it is more heat-resistant and has better toughness.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (6)