Tip jar ♥ https://ko-fi.com/cosmicnimbus
Patreon - https://patreon.com/CosmicNimbusPrinting
Gumroad - https://cosmicnimbus.gumroad.com

Hi there !

Ok I know, you're not meant to have your phone in the shower xD But I go to Youtube University every chance I get. I used to use a car windshield holder, but it broke, and I had some modifications I wanted to add to it. 

So here's my phone holder for the shower, with an amplifier horn. It has an omni directional mount clip, so you can twist your phone to different orientations. I added a thread and nut to it, so you can tighten this so it doesn't droop - it seems to do the trick! I went through a bunch of different iterations, but I think this one is the best as it is the most compact. It fits my Pixel 6, and my partner's Iphone 14.

HOLSTER

Version 2
- Added small notch for the edge of the screen in Vertical orientation.
- There is also an option with a grill. Grill friction fits in place

MOUNT

All the mounts have a screw and bolt to increase the pressure on the omni connection (ball mount). There are a few versions of the mount for where it connects to the shower

Mount 1
- For square shower edge finish that has 22mm across, 24mm high.

Mount 2
- For a glass pane, with a vice screw

Mount 3
- For a wider pane or edge finish, with a vice screw

PRINT

I printed this in Polymaker Polyterra dual colour PLA, at 0.28mm layer height, with 15% infill. I printed the holster with a brim and supports for the centre of the horn, the round edges on the bottom, and the ball on the back, but blocked out the support for the rest of the model. Every other part prints with no brim or supports.

Any modifications you want let me know

Happy printing !