IKEA Skadis Spacer
Copyright Claim
IKEA Skadis Spacer
Boost
47
167
22
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
Designer
23 min
1 plate
0.2mm layer, 3 walls, 15% infill
24 min
1 plate
Open in Bambu Studio
Boost
47
167
22
1
229
140
Released
Description
A simple spacer for your IKEA Skadis. It does not require any screws.
Measurements:
Total height for the spacer including the peg is 25mm, without it 20mm.
Fits Skadis perfectly that have a gap of 20mm (0.787 inches) to the wall.
Comment & Rating (22)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
It's okay
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
easy and fast print out. thank you
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Perfect fit.
(Edited)The designer has replied
1
Reply
You are not suppose to screw these into the wall. They are just spacers for the lower part of the board.
(Edited)0
Reply
Thank you for the comment. I updated my rating due to your explanation.
(Edited)1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Passen perfekt.
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Thank you for this very convenient design!
As a side note concerning the design decisions for 3D printing: better choose a chamfer over a fillet to face the plate.
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Works as intended. I may modify it to add magnets to the bottom to stick to the side of my X1C.
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
passt
1
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld