Fishing Rod Re-Liner

Fishing Rod Re-Liner

Boost
4
8
0

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 3 walls, 20% infill
0.2mm layer, 3 walls, 20% infill
Designer
38 min
1 plate

Boost
4
8
0
0
6
9
Released

Description

This is a handy little holder to reline/restring your fishing reel. I designed it around the Berkley Trilene Fishing Line spool. The dimensions of the spool is 89mm diameter by 22mm depth. Central hole diameter of spool is about 10mm. You load your spool on the holder which retains it with a slightly wider post at the end with a slit for pressure relief. Place the hook over the top of your rod. This should accommodate most rod thicknesses up to 20mm diameter. Tie a knot on your fishing line around the spool of your reel then begin to reel with slight pressure on the line. This keeps you from having the new spool of line on the ground while restringing.

 

I am open to any recommendations or changes you would like seen with this model.

 

I printed this with PLA but would recommend PETG for greater durability and water resistance.

I didn't use any supports but you can use some on the steep overhangs on the hook portion.

20% adaptive cubic infill.

3 Walls

Comment & Rating (0)

Please fill in your opinion
(0/5000)

No more