COFFEE DISPENSER (REVISED with Back Open Containers and Direct Mount)

Sorry, I couldn't take any pictures of the revised version yet but literally the dispenser is the same only having back open containers for easy fill).

Watch the video (Old Version):
https://youtu.be/BWoMwAzL7AI

Just put your coffee pot (or mug) under the dispenser and turn the knob 180 degrees and a standard portion of coffee is dispensed into your pot.
Pour some hot water and enjoy your coffee.

STL FILES:
There are 8 thing files of which 5 of them are optional (check-out before print):
1) The DispenserDirect Mount (or Mount with Optional Cradle below)
2) Cylinder Spoon (12cc)
3) Cylinder Spoon (24cc) Optional
4) Cylinder Spoon (5cc)_ Optional (upon request)
5) The Cylinder Spoon "Lock Cap"
6) The Wall Mount CradleOptional
7) Back Open Coffee Container Optional(*) (*)
8) Back Open Sugar Container_Optional(*) ()

() The Containers are optional as you can twist any standard/universal PET bottle onto the dispenser.
() Thanks to @DjiZon who inspired me to make this additional container for those who want to use the dispenser for sugar instead of coffee.
() Thanks to @wpjessie who inspired me to add back-cap for the containers for easy fill.

MOUNTING AND USING INSTRUCTIONS:
While mounting the Dispenser you can insert the 5cc, 12cc or the 24cc Cylinder Spoon as desired.

After inserting the desired Cylinder Spoon in the Dispenser, lock the cylinder inside the Dispenser with the "Lock Cap". Push hard and click.

You can either mount the Dispenser directly to any vertical surface (preferably to a wooden surface) with 4 small screws or;

You can also use the the Cradel which you mount again to any vertical surface (preferably to a wooden surface) with 4 small screws and slip the Dispenser from the open top side.

To change the Cylinder Spoon with another one, force pull the "Lock Cap" until it's relased and change the Cylinder Spoon and then lock it again as before.

You can now fill the conatiners with coffee or sugar without unmounting them from the wall or from their cradels (while they are in use). Just twist open the "bottom" of the conatiners on the top (Back Open Cap), fill them and twist close before they exhaust. Back open cap is standard and fits any conatiner (sugar or coffee). Accustom the cap to its slot at the bottom of the chosen conatiner before first use. You can lubricate it with a piece of dry soap.

OTHER NOTES:
Suitable for grain/granular coffees; as powder coffees stick to each other and jam the container neck (at least the portion dispensed would not be standard).

Keep the Dispenser and its parts away from moisture to avoid sticking and jams in due course.

Health Warning: PLA is non-toxic but may keep bacteria in the long term. Please check 3d print material's health issues before use.

PRINTING INSTRUCTIONS:
Filament: PLA
Layer Height: 0.28mm
Infill: 15%
Supports: NONE
Build Plate Adhesion: NONE

Happy printins...:)

Creality

No

0.28