Mickey Mouse Light Switch Design With Lip

Remixed by
Copyright Claim

Mickey Mouse Light Switch Design With Lip

Remixed by
Boost
2
6
7

Print Profile(2)

All
A1 mini
P1S
P1P
X1
X1 Carbon
X1E
A1

0.3mm I.L.H,  0.2mm layer, 2 walls, 15% infill
0.3mm I.L.H, 0.2mm layer, 2 walls, 15% infill
Designer
23 min
1 plate
5.0(1)

0.3mm ILH, 0.2mm layer, 2 walls, 15% infill, 3mm lip
0.3mm ILH, 0.2mm layer, 2 walls, 15% infill, 3mm lip
Designer
23 min
1 plate
5.0(1)

Boost
2
6
7
0
5
2
Released

Description

I originally printed the model by @Ladamtla, but then couldn't figure out how to put it on top of the switch (now I am guessing you could use double-sided tape), so I added a little lip to the bottom.

OPTIMAL PRINT SETTINGS:

Initial layer height: .30mm

Bottom surface pattern: archimedean chords

Make sure heat bed is cooled before taking off print.

You may need to loosen the top screw a little.

Comment & Rating (7)

Please fill in your opinion
(0/5000)

Print Profile
0.3mm I.L.H, 0.2mm layer, 2 walls, 15% infill
super cool
The designer has replied
0
Reply
thanks
0
Reply
Tried to print this 4 times, and every time, it would lay a black base layer down instead of the white layer...not sure what I'm doing wrong
The designer has replied
0
Reply
Sorry for the problem, it’s possible that you switched the colors up. Sorry.
0
Reply
Replying to @lauphilips :
Cool, thanks, buddy, I'll try again tomorrow, and report back
0
Reply
Print Profile
0.3mm ILH, 0.2mm layer, 2 walls, 15% infill, 3mm lip
The designer has replied
0
Reply
Thanks
0
Reply
No more