Twin Slot Wall Rail Spool Rack

Copyright Claim

Twin Slot Wall Rail Spool Rack

Boost
13
20
5

Print Profile(4)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

Support for PLA (Easier Cleanup)
Support for PLA (Easier Cleanup)
Designer
6.3 h
1 plate

Standard Support (Harder Cleanup)
Standard Support (Harder Cleanup)
Designer
5.3 h
1 plate

Four ClipOn Labels
Four ClipOn Labels
Designer
48 min
1 plate

Single ClipOn Label
Single ClipOn Label
Designer
24 min
1 plate

Boost
13
20
5
0
6
0
Released

Description

A simple spool rack for twin slot wall rail, printed on it's side with 8 perimeters for maximum strength.

Endcaps prevent spools from slipping of the end and add a buffer instead of a sharp metal edge.

Clip on labels are available for manually adding text in the slicer or just standard 12 mm label tape.

Required Hardware

2 x Aluminium Pipe (Or other round stock) Ø 25 mm

2 x Twin Slot Wall Rail (Slot: Length 25 mm, Width 4 mm, Spacing 25 mm, Center to Center 10 mm)

Notes

Made with the personal version of Autodesk Fusion 360 therefore non commercial only.

Source file included.

Comment & Rating (5)

Please fill in your opinion
(0/5000)

Is there something like this that you can make to hang on a wall versus sit on the floor?
The designer has replied
0
Reply
What do you mean? This is hanging on the wall using a twin slot wall rail as per required hardware.
1
Reply
Replying to @LayerCake :
I apologize I was looking at the filament rack. I like this one too. PLA is strong enough?
0
Reply
Replying to @LayerCake :
meant to reply here sorry
0
Reply
No more