Jason Voorhees - Friday the 13th - HueForge

Can be rescaled just remember not to change the Z axis.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 150x150mm in size
You may print at higher layer heights below the Min Depth of 0.8mm
The Max Depth is 3mm and the Actual Depth is 2.4mm

Filaments Used:
PLA+ Sunlu Black Transmission Distance: 0.6
PLA+ Esun ePLA-Lite Red Transmission Distance: 6
PLA+ Sunlu White Transmission Distance: 5
PLA+ Sunlu Grey Transmission Distance: 2

Swap Instructions:
Start with Black
At layer #10 (0.88mm) swap to Red
At layer #13 (1.12mm) swap to White
At layer #16 (1.36mm) swap to Grey
At layer #22 (1.84mm) swap to White for the rest.
Thank you!