This is a Hueforge filament painting of my favorite Hyrulean Hero, Link. The frame for all of my, and probably the vast majority of 200x200 prints is HERE.

*

This is a simple 4 color print that can easily be done by people with or without AMS/MMU units. If you have an A1 mini or any other printer with a bed smaller than the capacity to print 200x200 you can use the slicer to scale the model in the correct profile for your multi color setup just make sure NOT TO SCALE THE Z dimension. I would recommend not scaling smaller than your largest comfortable print area or you will be compressing the same amount of detail into a smaller area and it will probably get muddy, 0.2 Nozzles may mitigate some or all of this problem depending on the model and the size it is scaled down to.

*

IMPORTANT: READ BEFORE PRINTING

*

I have uploaded two 3MF profiles. One for people with a single AMS, and one for people with NO AMS.

*

To print with 1 AMS units all you need to do is load the colors in order and print.

*

To print with NO AMS unit you just need to do manual filaments swaps every color. The 3MF is set to pause at the correct layer heights. At each pause load the next filament color in order by following your unload/load procedure for your particular printer, then hit resume. Repeat until complete. This will be once per color over the entire painting. You have a decent amount of time between swaps.

*

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm. There are some recommended speed changes in my 3MF files and a layer height modifier to print the first 0.64 mm @ 0.16 mm layer height to speed up the print as there is no blending on those layers.

*

Like all of my models this is strictly for personal use. The photo attached is the printed model and frame.

*

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size
You may print at higher layer heights below the Min Depth of 0.64mm

*

Filaments Used:

*
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Gray Transmission Distance: 2
PLA BambuLab Matte Ivory White Transmission Distance: 3.5

*

Swap Instructions:
Start with Black
At layer #11 (0.96mm) swap to Blue Gray
At layer #13 (1.12mm) swap to Gray
At layer #20 (1.68mm) swap to Ivory White for the rest.