penguin QQ企鹅

Copyright Claim

penguin QQ企鹅

Boost
24
42
2

Print Profile(2)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
2.3 h
4 plates
3.0(1)

For X1, one plate only, print by object, fixed pupils @ 95%
For X1, one plate only, print by object, fixed pupils @ 95%
2.2 h
1 plate

Boost
24
42
2
0
75
8
Released

Description

penguin QQ企鹅

Comment & Rating (2)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
Sorry but this model prints good but then many problems face.
(Edited)
Support Issue: Removing supports from the back of the penguin is hard and ruins the model. I understand maybe there's no much to do about it. You should straight out the bottom of belly and receiving part on the main body.
Other Issues: I can't get the pupils fit the eyes holes, no matter how many energy I apply, will try reducing them. Also with glue belly won't resist much attached to body, consider creating a hole in the belly and a corresponding pin in body.
0
Reply
Reduced eyes at 95% in both X and Y and printed again, now they fit like a charm.
0
Reply
No more