Flash Logo Hueforge Desk/Wall Decor
Printed on Bambu Lab A1
Filaments Actually Used:
PLA Elegoo Black
PLA Elegoo White
Rapid PLA+ Elegoo Red
Rapid PLA+ Elegoo Yellow
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 150x150mm in size
You may print at higher layer heights below the Min Depth of 0.64mm
The Max Depth is 2.4mm and the Actual Depth is 2.5mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Red Transmission Distance: 4
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments
Swap Instructions:
Start with Black
At layer #9 (0.8mm) swap to Red
At layer #15 (1.28mm) swap to Yellow
At layer #24 (2mm) swap to Jade White for the rest.