Tiki Torch Mount

Tiki Torch Mount

Boost
2
2
0

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 4 walls, 15% infill
0.2mm layer, 4 walls, 15% infill
Designer
3.6 h
1 plate

Boost
2
2
0
0
0
0
Released

Description

I was tired of my tiki torch poles falling over, so I created a two part mount. The dovetail mount has two countersunk screw holes that fit wooden decking screws (among others I'm sure).

 

Print the mounting piece flat, cup as is. I printed the mount at 100% infill with 4 walls (to resist cracking while screwing), and the cup at 15% gyroid with 4 walls.

 

Just print the pieces, screw the mount to the post, slide on the tiki torch cup, insert torch. Please note the stoppers on both the cup and mount. Stopper on mount needs to be on the bottom of the post or the cup will slide off (see pictures if unclear).

Recommend an outdoor-hardy filament (pictures of model in PETG). 

Comment & Rating (0)

Please fill in your opinion
(0/5000)

No more