hey Folks, This small support for flush side cutters was simple to make but satisfying.
It's my first tool holder, I hope you like it.
I have inserted a cavity inside it in which you can insert a magnet.
To Layer 10 just insert a pause as I show you in the figure, so that the printer can stop and you can insert the magnet.
To be on the safe side I put a drop of glue under it.
I used a neodymium magnet, as you can see in the photo, about 10mm x 1.7mm.
Done this just restart the press and you're done.
If you have any questions, write me an email or a comment ( F@CKSIMILE.IT This is my email).