Fishing Rod Rack - Holds 8 Rods

Fishing Rod Rack - Holds 8 Rods

Boost
29
40
1
In Contest
Fishing Gear

Print Profile(1)

All
A1

0.28mm layer, 2 walls, 15% infill
0.28mm layer, 2 walls, 15% infill
Designer
6.9 h
2 plates
4.0(1)

Boost
29
40
1
0
22
10
Released

Description

I designed this to organize my fishing poles. Prints in two pieces. You will need to add some super glue to the top of the bottom piece to make the top piece more sturdy.

 

Measures 6 inches tall x 9 inches in diameter. 

The holes are 1.5" in diameter.

Comment & Rating (1)

Please fill in your opinion
(0/5000)

Print Profile
0.28mm layer, 2 walls, 15% infill
It's an uncomplicated design but those tend to be the most effective. A few notes from my expirence. I printed with some older Sunlu Filament and had some many bed adhesion issues. Likely due to the Infill contracting and 'pulling' the base from the bed (Textured Plate). After 4 Fails, I found that by turning off the Aux fan I could get a complete print without issue.
1
Reply
No more

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.