Universal Spool Weight for AMS

Universal Spool Weight for AMS

Boost
64
163
17

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
1.8 h
1 plate
4.3(16)

Boost
64
163
17
8
199
119
Released

Description

“Universal Weight for AMS”

  • adaptive not only for Bambu spool but olso for eSun(normal, cardboard, else) spools or more vendors.
  • with easy twist it can be lock on spool.
  • no more dropping batteries! There is a battery cap inside.
  • the battery cap has three holes to check the battery's condition if they leak or not.
  • do not get injury from the weight or spool. There are handles on both pieces.

 

Adaptive for lots of spools (for AMS)

 

The Plus pole should be on top of the holder.

 

You can pack 6 ran out AA-batteries inside and close the cap.
The cap screw is so sexy. Just try!

 

We have three holdes on the cap so we can see the battery's leaking or not. (It's quite important I think)

And there is an adorable FOX mark on.

 

With handles, you can easily twist both bodies to tighten on the spool.

And there's no way to harm your hands dealing with sharp edge of printing parts or even from edge of spools.

 

There is a lock mechanism so you can lock them together even they are not installed on spool.

You can here click sound when you lock it. Have a try It's so satisfying.

Just print any color you want!

 

================= <print guide> ================

!!! no support needed !!!

Every sides designed with consideration of the overhang angle: max 60 degrees or bridge.

Even you don't need any brims or rafts. Just a line of skirt's fine

(depends on the bed condition, sometimes brim needed)

 

 

Comment & Rating (17)

Please fill in your opinion
(0/5000)

Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
printed easy, looks great, love the middle locking piece to ensure the batteries don't fall out during installation, and to allow for periodic checks for leaks.
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Strength Issue
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfect!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
clever design
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Works for most spools - I had a few too deep and the ends would not screw into each other. All other spools have been fine, and the weight has helped them to roll better in my AMS.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Bed Adhesion Issue:this is the first time I be had an issue with adhesion. cool print will try again. looked like it would be good. what printed was good.
The designer has replied
0
Reply
I'm so sorry for that. In that case brim can help you.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply