This is 4 color Hueforge of planet Mercury.
Its part of my project to make all planets as a hueforge pictures, so i can hang them on my wall.
I had to change the size to 100x100, because of MakerWorld upload limitations. The raw model is 180x180. You can change the size to your liking in the slicer.
Do not adjust the thickness (Z) in your slicer!! The layers will not come out right. You can adjust the other dimensions (X,Y) though to make it bigger or smaller, just not the thickness.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 100x100mm in size
You may print at higher layer heights below the Min Depth of 0.32mm
The Max Depth is 1.8mm and the Actual Depth is 1.8mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA DevilDesign Gray Transmission Distance: 1.7
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments
Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Blue Gray
At layer #11 (0.96mm) swap to Gray
At layer #14 (1.2mm) swap to Jade White for the rest.