Oddish Pokemon Planter
Boost
160
265
27
Print Profile(2)
0.2mm layer, 2 walls, 8% infill
Designer
4.4 h
4 plates
0.2mm layer, 2 walls, 15% infill
4.9 h
2 plates
Boost
160
265
27
14
334
440
Released
Description
My own variation of the Oddish Pokemon Planter that's floating around. I wanted one where I could print the eyes and mouth as seperate colors and then just glue them into place.
Print 2 Eyes and 4 of the risers for underneath to allow water to drip out into the drip plate. The eyes and mouth should rest perfectly inside with a drop of glue
Comment & Rating (27)
All
Print Profile
0.2mm layer, 2 walls, 8% infill
nice print, but the eyes and especially the mouth are hard to get fittet perfectly and there is a high chance to get super glue on the visible area.
0
Reply
Print Profile
0.2mm layer, 2 walls, 8% infill
This is way too cute! I can't wait to print the base, eyes, and mouth for it. ❤️
0
Reply
Boosted
I’m in love
0
Reply
Print Profile
0.2mm layer, 2 walls, 8% infill
Print comes out well. Eye parts are flexible enough to conform to the space but the mouth needs to be melted a bit to fit properly. Mouth and tabs are glued into the main body.
0
Reply
Print Profile
0.2mm layer, 2 walls, 8% infill
Vame out really nice. Parts fitted perfectly.
Used PETG with 0.16 layer height.
Scale 130% and 70%.
(used the plate from an other project)
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 8% infill
great and easy print. fits my plant perfectly
0
Reply
Print Profile
0.2mm layer, 2 walls, 8% infill
Printed two of these for my succulents and they are working wonderfully.
0
Reply
Print Profile
0.2mm layer, 2 walls, 8% infill
printed well.
0
Reply
easy and cute
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
© 2024 MakerWorld