laifen toothbrush stand / Laifen electric toothbrush charging stand

laifen toothbrush stand / Laifen electric toothbrush charging stand

Boost
14
34
7

Print Profile(2)

All
X1E
P1S
P1P
X1
X1 Carbon
A1
A1 mini

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
3.1 h
1 plate
5.0(4)

0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
2.8 h
1 plate

Open in Bambu Studio
Boost
14
34
7
3
64
26
Released

Description

Content has been automatically translated.
Show original

Recently purchased a Laifen electric toothbrush, but the product did not come with a suitable charging stand, only a magnetic charging cable. This makes it difficult to find a convenient place to put the toothbrush while charging, so I designed a charging stand.

 

Some design highlights that I think are quite good

  1. The toothbrush placement angle is slightly tilted backward by about 8 degrees, making it easier to pick up and put down
  2. There is a drainage hole in the toothbrush placement area to prevent water accumulation
  3. The bottom is designed with a complex cable winding and wire outlet to meet the needs of placement in various corners
  4. There is also a storage space behind the stand for storing spare toothbrush heads or extra wires.

 

This model is not an official product of Laifen, it is a personal amateur work.

Due to design requirements, the Laifen brand mark was used. If Laifen's legal team has any concerns, please contact me privately.

Comment & Rating (7)

Please fill in your opinion
(0/5000)

I printed one, the charging port is a little tight, now I'm going to enlarge it a bit and try printing another one
The designer has replied
Show original
0
Reply
I left a 0.2mm clearance tolerance at the charging port, the shrinkage may vary depending on the material, I made it slightly looser here
Show original
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
this print was very nice and smooth.
0
Reply
I printed one using PETG, and when I charged it yesterday, I found that the magnetic connector is slightly off. Is it a material issue or something else? The toothbrush is the ABS version, not the stainless steel version.
Show original
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.