This is a weather proof case for zigbee door/window sensors.

Original case have an opening for reset/pairing, and another for the LED. I wanted to use it on the outside door. I thought it wont last long if left with the original cover, so Ive made a new one out of ASA (PETG should be fine also).

The print has a PAUSE on the 10.00 mm height so you can place the magnet inside. Continue the print after placing the magnet so its completely sealed.

The case and the cover fit by pressure, and has some indents on the sides to remove the cover with a screwdriver when you need to replace the battery.

You can add a 1mm diameter silicon string all around for better sealing if you want.

The zigbee sensor used is the one in the picture. Other models wont fit even when they may look the same.