Brackets to support the heater bed cable from drooping down and snagging destroying itself. This is great option when space is limited when you need to place the printer close to a wall as possible to maximize space.

Redesign of my original bracket design to be a more finished look. Goal was to make it look like it should come from factory with the machine. Both still work great just another option.

If you wish to use with bed sheet aligners, you must use with latest version V3 Because of the tight tolerances between the bed and the bracket. Older version will not work. New version has been slimmed down.

Anycubic Kobra 2 Max SNAP-ON Bed Sheet Aligners V3

If you have older version of Bed Sheet Aligners and do not wish to upgrade to new version you can use the original version of Bed Cable Support.

Alternative Original Design: Anycubic Kobra 2 Max Bed Cable Support (Split Version)

Print Instructions:

• Print in Place
• 25% infill
• No Supports Needed
• Can Use Brim if your printer does not have good enough adhesion. (Should Not Need if printer is dialed in)

Install Instructions:

Step 1.

• Slip under the bottom nut of support brace. Will need to tilt back like in picture.

Step 2.

• Make sure the bracket is pushed all the way down covering the bolt head. After Bracket is tighten down you will still be able to lift and access bolt if needed.

Step 3.

• Install cable and secure with your method of chose bolt on, wire tie, heated insert versions.

Step 4.

• I have included Under Printer Wire Management Cable Clip v1. Use this to route the Heated Bed Cable Under Printer Securely

This model works great paired together with:

Anycubic Kobra 2 Max SNAP-ON Bed Sheet Aligners V3

Anycubic Strain Relief V2

Change Log:

2/24/2024 Uploaded V1 of Threaded, Tie Wrap, Heated Insert, Full Bed Cable Supports