Search models, users, collections, and posts
NES cartridge Switch game holder
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
5.1 h
5 plates
Open in Bambu Studio
Boost
135
272
16
10
138
39
Released
Description
Tried to make a exact replica of the NES game cartridge and at the same time find some space to put my switch games.
I separated the risers/spacers/thingamajigs to be able to print without supports and get the same surface finish as the rest of the print. They need to be glued in place after printing
Other hardware you´ll need is 2 x M3 13-20mm screws and 2 x 8x3 magnets.
Also added a sleeve for that extra retro nintendioan feeling :P
Easiest way to remove the games is to push on the far left of the game with your thumb an pull with your index finger. letting the game pivot around the base of the holder.
Printed without support with eSun PLA+
Happy printing :)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (16)