Just A Cute Flexi Pig

• Movable head and ears
• Print in place
• Curly tail that spins in 360 degrees
• Ball jointed legs that can rotate to almost any position.
• This little guy can stand or sit and is a perfect for any pig fans

The included print profile is for 5 pigs and will fit on any Bambu Lab printer. This is in order to limit the amount of waste created due to being a multi-colour print.

You can of course delete as many pigs as required if you don't mind waste, or also add more if using a larger build plate than an A1 Mini.

I wouldn't recommend scaling the pig down as tolerances in the joints are quite tight, but you can scale up as large as you like.

A clean bed is essential for a successful print. The tail has some very small contact patches on the first layer and can fail if there is any oily residue on the build plate. I would even recommend adding some adhesive like ‘3DLac’ to ensure they stay in place. 

The legs require breaking free post print. - This does require a little bit of force and will give a satisfying ‘crack’ as they come loose. This allows the ball joints to retain some stiffness for arranging the pig into different positions. Please refer to the following picture…

Thanks for looking!

Please rate and review your printing experience :)