Print Profile(1)
0.6mm nozzle 0.3mm layer, 2 walls, 15% infill
Designer
48 min
1 plate
Open in Bambu Studio
Boost
2
5
1
0
12
5
Released
Description
A holder for your headset, designed for mounting on cubicle walls. Perfect for the office!
You can hang it on anything, as long as it can fit in the 37,5 mm opening.
If you struggle with bed adhesion, consider adding a brim. The model is quite thin, and does not give much surface area on the print bed.
Comment & Rating (1)
All
Print Profile
0.6mm nozzle 0.3mm layer, 2 walls, 15% infill
Great print, no issues!
Did put few discs down in slicer just in case for bed adhesion. Most likely wasn't needed.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
© 2024 MakerWorld