These are 2D files in several formats so that you can make your own stencils or stickers to apply to the Alioth IOM 3d printed boat.

I included the hull numbers just so you could get a reference for the size. The font is 20mm Arial Rounded Mt Bold. I used lowercase letter “L” for the ones because I like the look better.

You can see in the logo photo sequence how to assemble it.

1. Remove the extra vinyl.
2. Then cut just at the edge, leaving a millimeter of piece of white backing.
3. Align the edges and put a bit of tape at each end.
4. Apply the transfer tape and apply.

A spray made of denatured alcohol diluted 50% with water and a drop of liquid soap will allow you to slide the vinyl around a bit. Then squeegee it to apply.

Here is the build thread https://www.rcgroups.com/forums/showthread.php?4112127-Alioth-3d-printed-IOM-sailboat

Category: R/C Vehicles