Pot lid holder
Copyright Claim
Pot lid holder
Boost
7
35
7
Print Profile(1)
0.24mm layer, 3 walls, 15% infill
Designer
1 h
1 plate
Open in Bambu Studio
Boost
7
35
7
0
31
28
Released
Description
It holds your lids vertically.
Comment & Rating (7)
All
Print Profile
0.24mm layer, 3 walls, 15% infill
not sure why but it said it was done like this
The designer has replied
0
Reply
It was designed to hold the pot lids as shown in the pictures. The other folks who have printed it do not seem to have had the same problem. Check your printer settings, make sure your filament is dry, and all the other usual suspects for a failed print.
Best of luck.
0
Reply
Print Profile
0.24mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.24mm layer, 3 walls, 15% infill
Clean simple design with enough strength to do the job, though I find the angle and spacing doesn't work too well for my lids and their handles. Holds them up ok but getting them in and out is a hassle as they mostly lean on each other and not the supports. Still, the best design I've found for the task! Thank you!
1
Reply
Print Profile
0.24mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.24mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.24mm layer, 3 walls, 15% infill
1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld