Ducati Key Hook
Print Profile(1)
Description
Summary
A friend asked me to make them a Ducati key hook after liking my Audi design one, so I thought I would share the results with you lovely lot :)
Enjoy!
If you love this design, feel free to buy me a coffee and I will love ya for it :)
Print Settings
Printer Brand:
Creality
Printer:
Ender 5
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
50%
Filament: ICE PLA
Wishful White & Romantic Red
Notes:
It is very detailed, so it took some post processing with a craft knife to get the inserts to fit as it's so small, the tolerances are minuscule!
I couldn't even get cura to slice the middle of the 'A' as it was too small, so I just used a tiny bit of scrap thinned out filament. I have the same issue with the middle of the D so I did the same. I only included the files as some other printers may be finer detailed than mine.
As the fit was so tight, I didn't even need to use any glue.
The idea is to screw it to the wall (not to tight as it might crack) and then the bottom part red part of the logo pushes in to cover the screw. Should you need to remove the hook in the future, a fine craft knife should enable you to pop the cover back off again :)
License
Comment & Rating (6)