San Francisco 49ers LED Light Box
San Francisco 49ers LED Light Box
Boost
28
57
16
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4.3 h
2 plates
Boost
28
57
16
0
97
119
Released
Description
2 Pieces included in the file - I designed them to be printed on a Bambu Lab printer with AMS
The front plate - this is the part that will need to colored to your liking and printed face down(thats how it should load into the slicer)
The backplate - this piece will fit on the back - it might need to be glued depending on your printers tolerances.
I use these lights as they are the best I could find after trying several other options
Comment & Rating (16)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
back plate does not fit without cutting pieces off of front. no way this was test printed before being uploaded! it’s ashamed because it truly is a beautiful model.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
waste of filament. backplate doesn't line up with the front. also the front is not connected very well to the design came apart when removing from cold build plate.
0
Reply
The front has too much over hang on the bottom edges, there is too much sticking out around the S on one side, and too much under the 4 on the other side. The areas in Green are the problem areas. I will see how I can shave them down
0
Reply
back does not go on without modifications
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice design but the backplate did not fit in.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Love it!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
absolutely beautiful thank you.
0
Reply
When I load the front on the printer, it is in separate pieces. How can it print in one piece?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld