Drill Dust Collector - Optimized Model
Remixed by
Copyright Claim
Drill Dust Collector - Optimized Model
Remixed by
Boost
9
29
2
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.4 h
1 plate
Boost
9
29
2
0
16
13
Released
Description
I found this on printables but wasn't very happy with the fact that you have to hold the dust-collector with one hand, so I modyfied this model to stay against the wall by it's own.
Support is only for optical reasons, I printed my 1st model without support on a Bambulab P1S ond it worked. The inside wasn't pretty bout worked fine.
Comment & Rating (2)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed pretty well but the tip deformed and the supports were a pain to get out. I printed them from Rosa3D Starter GlitterPLA. This might me improved but is such a large print that Is not worth the wasted filament.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld