This is 4 color Hueforge of Mountains near sea
Do not adjust the thickness (Z) in your slicer!! The layers will not come out right. You can adjust the other dimensions (X,Y) though to make it bigger or smaller, just not the thickness.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 180x180mm in size
You may print at higher layer heights below the Min Depth of 0.24mm
The Max Depth is 1.7mm and the Actual Depth is 1.7mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA JamgHe Green Transmission Distance: 6
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments
Swap Instructions:
Start with Black
At layer #5 (0.48mm) swap to Blue Gray
At layer #9 (0.8mm) swap to Green
At layer #11 (0.96mm) swap to Jade White for the rest.