I like to scale my hueforges up to 220x220. I couldn't find any frames this size so decided to make one.

A few quick notes:

• The frame is a friction fit for the hueforge.
• Make sure you take a good look at the all the sides when when putting the legs on the frame. The bottom of the frame is slightly angled (10 degrees), while the other 3 sides are all straight.
• I designed this frame with the intent of putting it on the provided legs, you should be able to easily add a negative part modifier if you wish to use this with a screw to mount somewhere

I used the Standard .2 bambu profile with the following modifications. I probably overdid it a bit, so feel free to adjust as needed.

• Wall loops: 4
• Bottom Shell Layers: 5
• Sparse infill: Gyroid @ 8%