Turbocharger charm for your crocs. For printing, I recommend to cut the model in 3 pieces for best printing experience. Then you don't have to use so much supports. For gluing, my recommendation is to use Bison superglue or classic Loctite.
Printing instructions:
■ Steel sheet
➔ at your own preference (textured PEI for PETG material)
■ Nozzle
➔ 0.4 or smaller for better resolution
■ Material
➔ PLA
■ Infill
➔ 15-20%
■ Circuits
➔ 0
■ Supports
➔ YES
Turbodúchadlo pre kroksy. Super ako darček pre fanúšikov áut. Alebo len tak pre zábavu. Pre tlačenie odporúčam model rozdeliť na 3 časti pre menší počet následných podpor a lepšiu tlač. Na následné zlepenie odporúčam sekundové lepidlá Bison v gély alebo klasický Loctite.
➔I will be very grateful for every download and comment feedback you post. Have a nice day!