This is a keycap with a hueforge of the Duke Nukem 3D logo on top of it!
Use the available print profile to print it directly.
But if you want to customize it, the Hueforge starts at 9mm, and then follows this :
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm
The Model is 13x13mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 1mm and the Actual Depth is 1mm
Filaments Used:
PLA BambuLab Matte Charcoal Transmission Distance: 0.1
PLA BambuLab Basic Blue Gray Transmission Distance: 2
PLA BambuLab Basic Orange Transmission Distance: 5.4
PLA BambuLab Basic Yellow Transmission Distance: 5.2
This print uses 4 unique filaments
Swap Instructions:
Start with Charcoal
At layer #10 (0.52mm) swap to Blue Gray
At layer #16 (0.76mm) swap to Orange
At layer #21 (0.96mm) swap to Yellow for the rest.