Bambu Spool, Imperial Remix
Remixed by
Copyright Claim
Bambu Spool, Imperial Remix
Remixed by
Boost
37
67
27
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
6.7 h
2 plates
Boost
37
67
27
1
261
408
Released
Description
Just a little remix of the standard Bambu Spool to give it a little look of an Imperial Crest. It maintains most of the strength of the original while adding a view of the filament from the side. I also added single 3mm holes on the hub of each half to secure filament if you're winding from another spool.
Notes:
- If using Bambu refills, the NFC tag will show on one side. I dig this, but some might not.
- I moved the label location in, so the remaining filament measure on the Bambu label doesn't line up.
Comment & Rating (27)
All
Works well, thank you!
Printed on P1S with Extrudr PLA NX2
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
No problems at all. Used PLA NX2 from Extrudr
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed this many times without failure
The designer has replied
1
Reply
Great to hear!
0
Reply
Curious, what is the small clip for on plate No 1 ?
The designer has replied
0
Reply
Thats the spool hub lock that comes with the original Bambu Spool design that this is remixed from. I don't actually use it, but left it on there in case anyone does.
0
Reply
thanks !
1
Reply
is it best to print without a brim ? I feel like it could cause issues on the rollers if the brim is not 100% cleaned off.
The designer has replied
1
Reply
Good call... I actually have this in the print profile I use, but I must've uploaded an earlier version. Updated.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
My go-to spool for bambu refill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The design is nice but I liked the rigidity of the spool's sides with its minimal flexing. I'll be using this in an AMS so I'll see how the long term stability goes. Most other printable spools are flimsy and flex or bend when fully loaded with a full 1kg filament roll. Well done!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Ich konnte alles so übernehmen. Top Einstellungen!
(Edited)1
Reply
woudl you be able ot add the holes to thread the filament through when respooling on V3 ? I dont see them in the profile. if you have the STLs too. Thanks.
The designer has replied
0
Reply
There are holes on the hub for inserting the start of the filament when respooling, and the STLs are available under "Download raw model files". Is there something I'm missing in your question?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Passt perfekt
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld