Iron Man Hueforge - Ready to print
Remixed by
Iron Man Hueforge - Ready to print
Remixed by
Boost
5
8
5
Print Profile(1)
0.08mm layer, 2 walls, 100% infill
Designer
2.6 h
1 plate
Boost
5
8
5
0
11
10
Released
Description
This is a Bambu 3mf file for the Iron Man Hueforge model updated by Lestrade.
Filaments used:
- Bambu Matte Charcoal to layer 5
- Bambu Matte Scarlet Red to layer 14
- Bambu Matte Lemon Yellow to layer 21
- Bambu Ivory White for the rest
.8mm layer height, .16mm first layer, 100% Rectilinear infill.
I disabled the prime tower as it collided with the STL, but there's plenty of whitespace and it probalby could be left enabled if moved to an the top left corner of the model.
It may be difficult to see in the picture, but the model has some artifacts in the whitespace on the left and an annoying ridge on the upper right. The former just means cleaning them off the build plate, the latter will need to be cut off or tolerated.
Comment & Rating (5)
All
Print Profile
0.08mm layer, 2 walls, 100% infill
seems a little thin on the black areas and red. and has some weird issues along the edge. but overall still looks pretty nice
The designer has replied
0
Reply
Those were the same as the source model - I didn't make any dimensional adjustments or try and clean up that edge flashing.
If I had the skill to do so, I would have, but alas, I don't.
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
Look like a comic book pge on my wall! Amazing
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
The designer has replied
0
Reply
Thank you.
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld