Pumpkin Hat Stand

Pumpkin Hat Stand

Boost
0
0
0

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

Vase mode, 0.08mm layer, 2 walls, 15% infill
Vase mode, 0.08mm layer, 2 walls, 15% infill
Designer
6 h
2 plates

Boost
0
0
0
0
1
0
Released

Description

An old model from my backlog! It’s a pumpkin-themed stand to hold your hats. More of a hat stand than a head-sized wig stand. Comes with a couple of small indents on the bottom which fit 3M-style command strips; you may need to trim the strips themselves down to fit. I recommend printing the body in vase mode, printing the cap as you normally would, and then gluing the cap on top to complete the form.

Showcase here: 

Comment & Rating (0)

Please fill in your opinion
(0/5000)

No more