Print Profile(1)
0.16mm layer, 2 walls, 15% infill
18 min
1 plate
Open in Bambu Studio
Boost
1
9
3
0
11
7
Released
Description
Schlüsselhalter für AirTags.
Passend für 30mm Schlüsselringe.
AirTag wird direkt in den Druck eingelegt.
Langsam drucken mit 20 Shells.
Während dem Druck ab Layerhöhe von 5mm AirTag ohne Deckel mit Pinzette einlegen.
Ggf. dazu die Druckgeschwindigkeit kurz verringern.
Key holder for AirTags.
Suitable for 30mm keyrings.
AirTag is inserted directly into the print.
Print slowly with 20 shells.
While printing from a layer height of 5mm, insert the AirTag without the cover using tweezers.
If necessary, reduce the printing speed briefly or pause print.
Print Settings
Resolution:
0,2mm
Infill:
100%
Filament:
Material4Print PLA gold
Notes:
20 Shells
Comment & Rating (3)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
not very good, but it’s work
0
Reply
You have to insert the airtag during print at a layerheight of 5mm. See picture. Reduce printspeed or pause print to insert the airtag.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Turned out super stringy, even with speeds halved. No room to fit the airtag - I'm assuming I was supposed to add the airtag at some point in the print - but then it would be trapped forever.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld