This is a design by me, transformed into a filament painting using Hueforge.
If you scale it, dot change the height of the image.

I used glow in the dark filament on the last layerchange, but feel free to use any color of choice (i think bright colors would look best)

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.24mm

Filaments Used:

PLA MATTE Sunlu Matte Black Transmission Distance: 5

PLA+ Sunlu Grey Transmission Distance: 2

PLA+ Sunlu Orange Transmission Distance: 5

PLA Spectrum Glow in the Dark Transmission Distance: 5

Swap Instructions:

Start with Matte Black

At layer #5 (0.56mm) swap to Grey

At layer #8 (0.8mm) swap to Orange

At layer #13 (1.2mm) swap to Glow in the Dark for the rest.