21. May 2024 V2.1:

• Additional x16 version
• Mount updated

18. May 2024 V2.0:

• First release

V1: https://makerworld.com/en/models/466404

In my opinion, the V1 was still in need of improvement, so I developed a completely new concept from scratch.

As always, your feedback is very welcome.
 

What's new:

• The nozzle can be replaced as usual
• Different versions (x8/x16)

As the blades are very thin, I had the problem that they were not printable in the middle of the plate. However, this was not a problem in the front area.
 

So if you have the same problem, try placing the model on a different part of the plate.

Assembly:

	Insert part 3 with the thinner, angled side into part 2 It should fit snugly. If not, use glue Insert part 1 into part 2 Part 1 must be able to rotate freely, otherwise the hole in part 2/3 must be enlarged
	Now insert the combined part 2 into the housing hole It should hold by itself and still be removable with little force Place part 1 on the axle Press carefully on the center until the result looks like the picture You may need a little more force Make sure that there is a little space between the parts so that they do not scratch
	This was designed in Tinkercad with very simple shapes