This is the cheapest way to get affordable solder (approx. 15 EUR). You can buy the kit here (aliexpress.com). Once the kit is in place, you can print the box with the stand.

Insert the solder PCB board into the box, the opening in the box is tight enough for the board to hold there by itself. A switch is inserted into the box from above (aliexpress.com), a DC connector for power is inserted next to it (aliexpress.com). I should also mention that it is necessary to insert 4x M3 nuts into the box during printing, using the M601 command. After that, don't forget to connect the power cables as in the picture in the gallery, then just screw the cover with 4x M3x12 mm screws.

As for the stand, two variants are available. The first is the main one and you need to stick 4 non-slip stickers with a diameter of max. 13 mm on it from below, you can see it in the photo in the gallery. The second option is without recesses for anti-slip stickers.

Printing without supports, Infill: 20%, Material: PET-G

Share your printed model.