Homer Rocking the Banana Hammock (5 colors easily done with single AMS and only one swap at the beginning)

Build Plates
1. Magnet

2. 2 x Magnet

3. 3 x Magnet

Printed in:

Elegoo Black PLA+

Bambu Basic Red PLA

Sunlu White PLA+

Sunlu High Speed Yellow PLA

Kexcelled Light Brown Matte PLA

These are printed facedown. I use magnetic tape to stick these on the wall, but double sided tape should work. The key rings are from amazon. Line widths for the first layer are heavily reduced so the teeth on the keychain show up.

NOTE ON USING A SINGLE AMS: if you print from my profile with a single AMS, please do the following to achieve the 5 colors.:

-Load Brown, red, white and yellow.

-When sending the print job assign Black and Brown to the same AMS slot.

-Brown will print first, only one layer is needed for it. Soon as brown is done and yellow has started, remove the brown and put the black in, manual spool changes are now all done.

IF YOU SLICE YOURSELF THIS METHOD MAY NOT WORK UNLESS YOU SET FILAMENT COLORS IN BAMBU STUDIO IN THE SAME ORDER I ADDED THEM AND HAVE CUSTOM COLOR PRINT SEQUENCE SETUP THE SAME.

Hope you like my models, if you do please leave a rating and check my profile here: https://makerworld.com/en/@phillipjfry

Maybe buy me a coffee, I go through lots of it, thanks.

Have a great day and happy printing!!!