1 Layer Harley Davidson LED logo lamp Remixed by OldSpice3d

Remixed by

OldSpice3d

Art>Signs & Logos

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 1 walls, 15% infill

Designer

14.2 h

9 plates

4.3(3)

Boost

103

184

Released

Description

Remix version called 1 layer:
- 1 single layer for all colors, perfect for PEI or engineering plate
- New box adapted to the 1-layer version with reinforced thickness to avoid too much flexibility of the back plate.
- Also an addition of a 1-layer version that adapts to the original box (original model)

This new 1-layer version features an insert that fits into the box, so there's no need for glue, but it can still be removed.

Comment & Rating (4)

@cstoutr

Print Profile

0.2mm layer, 1 walls, 15% infill

A little tricky to put together but printed very nice

@munchers2010

Print Profile

0.2mm layer, 1 walls, 15% infill

This light box looks awesome! it was easy to print as well. the issue is that its almost impossible to glue together and still maintain a clean outer appearance. i created some small rectangles to glue the three pieces of the box together. i am still trying to figure out how to glue the three panels together and seal the gaps between the three. ill figure out how to add my little rectangles to the remix section.

@selliott5514

i use bsi gap filling super glue with painters tape on the front and apply thing line of glue then spray with bsi activator which instantly sets the glue then go over the seams with black hot glue and it comes out perfect