"Cat 2" Earrings - Modified
Remixed by
Boost
8
4
2
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
17 min
1 plate
Open in Bambu Studio
Boost
8
4
2
2
3
5
Released
Description
I really liked the cat earrings Cosmin.solo uploaded, but I needed a few changes. I scaled to 75%, added a top loop to fit the earring hooks I use and I fixed where a bit of the ear did not print because it was now too thin after being scaled down. I thin cloned and mirrored the model. Cats are now 35 mm tall. Edits were made in TinkerCAD.
I use these earring hooks from Amazon: https://a.co/d/4sCADRe
Thanks to Cosmin.solo for source model.
Comment & Rating (2)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
Great print! The earrings are thin enough, light, but have a nice place to attach earring hardware.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
looks great and a fast print.
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld