After receiving my new Elite Forman Onefinity CNC I searched online for parts to cap any holes or voids that could get dust build up.

All the models I was able to locate seem to be for smaller versions of Onefinity CNC's. This model was designed in Fusion 360 and if needed I can make revisions on request.

The wiring was run though holes in the table to keep a clean look and protect the cables from damage but this left a void in the table for shavings and dust buildup. 

The covers length (75mm) was based on the location of the 1" hole I drilled into the table to run the cables and may need to be adjusted based on your hole location. The tube has an ID of 40mm, height of 70mm with a 3mm slot on the right side for the limit switch cable.

I used (2) #6 fasteners to fasten the cover to the table, nothing is connected to the machine the tube is just butted up against it.

This is for the B Rail on an Onefinity Elite Forman CNC,for other Onefinity dust protections, and wire management prints, check the below links.

Onefinity Elite Forman - Fastener Cover

Onefinity Elite Forman - Y Rail Wire Cover

{Links to follow}