Very good model, but I would've loved a proper description and an explanation as to why it's showing as breakable in the picture when it actually isn't
The photo shows it broken in two but once printed it’s one piece. When I looked back on the print Timelapse I noticed there is what looks like a split in the model covered by the external walls. so I printed it again and took a sharpie marking where it looks like it’s meant to split and maybe have magnets. You can kind of see the mark at the bottom right in front of the third funnel. I’m going to cut there and see if it works. Update to come if it works.
this is almost like a toy from when I was a kid I've been wishing for since then. there was a piece that could be switched on and off in the hole. the titanic would sink. I've dreamt of someone making it so I could print it. this is so close.
The two parts didn't fit together unfortunately. I had to shave the squares down to fit the holes on the other side. Other than that, pretty nice model!
really cool model. but some instructions would be nice. what is the purpose of the holes in the bottom? what is the size of magnets required? super confused and it doesn't really swim that will