• 'Updated model

This is set up to be printed without AMS so there are pauses in the print to allow for filament changes.

Start with red. Switch to white at first pause at 29 minutes and 30 seconds. Switch to blue at second pause at 58 minutes and 2 seconds. Switch to brown at last pause at 1 hour 26 minutes and 11 seconds. You may adjust pauses in slicer base on your preference. If you want a solid-colored pop, just delete the first 2 pauses, leaving the popsicle stick pause at 1 hour 26 minutes and 11 seconds.

You will need a 12 mm X 2.3 mm magnet. Magnet sets can be purchased through amazon.

I have plans for two modifications of this in the works, one will fit the brick wreath and the other will be whole to use in children's play kitchen.