Rhea - Selfwatering Insert

Copyright Claim

Rhea - Selfwatering Insert

Boost
5
6
0

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

Rhea---Insert_140mm
Rhea---Insert_140mm
Designer
2.3 h
2 plates

Boost
5
6
0
0
4
1
Released

Description

This is the selfwatering insert for Rhea - Planter.

It has a waterindicator to see how much water is left. You have to stuff the underpart with styrofoam so that it floats. But be careful because this part is very fragile.

Before planting:

Please make sure that the rod is up to the top line of the cap when the water level is full (water up to the top edge of the inner pot). If this is not the case, then measure approximately the height of the rod from the cap and feel free to contact me! I will send you a new cap.stl with your measurements.

 

Standard Dimensions:

  • given in print profiles!
  • check STL-files for more caps!

Settings:

  • layer height: 0.2mm
  • line width: 0.42mm!
  • wall loops: 3
  • infill: 100%
  • You can also use your own settings on your own risk!

Note:

  • As you scale the pot the wall thickness will also change. Feel free to contact me for other Dimensions!
  • Insert is the same as in the Juno-Planter!

 

Update:

23.05.2024: Added new cap sizes!

 

 

Feel free to upload your makes!

Comment & Rating (0)

Please fill in your opinion
(0/5000)

No more