dsfasThis cool duck is filled with a passion for gaming! To print, print both halves of the ducks with the square, which will help with assembly. Print two base rings, one clear, and one in the chosen base color. Print one of everything else. Gamer duck can also be used to spice up any LED indicator!

Optional parts:

1x LED
2x 5x2mm round magnet
1x CR927 cell battery

Assembly Directions:

 Step 1: Make sure you print all of the required parts that are pictured below. The battery and LED is optional, and the 2 magnets, which are not pictured, are also optional.

Step 2: Install the alignment square to one half of the duck.

Step 3: Install the Main Headphone piece by aligning it with one side. Make sure the middle opening is pointing towards the bottom opening.

Step 4: Install the clear section of the headphones by inserting it into the side openings of the main part. Make sure the indent is facing towards the bottom opening of the duck. IF INSTALLING LED: insert the LED into the opening.

Step 5: Apply glue and push the other side of the duck onto the assembled side.

Step 6: Glue the two halves of the mouth together, and attach them with glue onto the front of the duck. There is an indent to show where the mouth goes.

Step 7: Glue on the headphone headstrap and the sunglasses.

Step 8: To install the Base, insert the clear ring first. Glue both rings. If desired, glue both magnets, one on the duck, and one on the base. This will help the duck stay on the base.

Step 9: Wait for all of the adhesive to dry. You are done! Congratulations on your Gamer Duck Adoption! :)